[. . . ] Film Data Sheet T-600 NotePad Integral Color Print Film
Description
1RWH3DG
Film Speed
ISO 640/DIN 29
ILOP
, QVWDQW &RORU )LOP
General-purpose, high-speed, medium-contrast, integral film for high definition instant color prints. [. . . ] If you get some paste on your skin, wipe it off immediately, then wash with water to avoid an alkali burn. If eye contact occurs, quickly wash the area with plenty of water and see a doctor. Do not burn battery or allow metal to touch terminals.
Limited Warranty
See information on the film box. "Polaroid", "NotePad", "Impulse", "Cool Cam", "OneStep", "JobPro", and "Write On" are trademarks of Polaroid Corporation, Waltham, MA 02451 USA.
Film Data Sheet Technical Data
T-600 Film Family
The information in this data sheet represents the typical performance of Polaroid's T-600 film family. However, there may be some variation between film lots.
Characteristic H&D curve for normal development
3 H&D Curves @ 70oF/21oC Blue Green
Recommended speed: ISO/DIN 640/290 Recommended processing time and temperature: Approximately 3 minutes at 700F/210C Balance: Daylight and electronic flash (5500oK) Contrast: Medium Resolution (1000:1): 7-10 line pairs/mm
2
Red
Sample Density 1 0 -3 -2 -1 0
Relative Log Exposure
D-Max: The density value for the film's darkest black. In prints, the whiteness of the brightest highlight, relative to the unprocessed print. Slope: The positive ratio of the log E increments of the straight line region of the curve, as determined by the 1/4-3/4 increment method. The slope of an H&D curve indicates the overall contrast of a film: low contrast slopes less than 1. 10; medium contrast slopes from 1. 10 to 1. 70; high contrast slopes greater than 1. 70.
Sample Density
Characteristic H&D curve for cold development
3 3
Characteristic H&D curve for hot development
H&D Curves @ 95 oF/35 oC
Blue Green Red
H&D Curves @ 55 oF/18 oC
Blue Green Red
Sample Density
1 0 -3 -2 -1 0 -3 -2 -1 0
2
2
1
0
Relative Log Exposure
Relative Log Exposure
Film Data Sheet Technical Data
T-600 Film Family
Reciprocity law failure A wide range of shutter speeds can be used without loss of film speed or requirements for color filtration. [. . . ] Reciprocity failure occurs during very long or very short exposures, requiring the photographer to increase exposure.
Reciprocity Law Failure
Blue 1. 8 1. 6 Green Red
Relative Log Exposure
1. 4 1. 2 1. 0 . 8 . 6 . 4 . 2 0 . 0001" . 001" . 01" . 1" 1" 10" 100"
Exposure Time (seconds)
Modulation Transfer Function
1
0. 8
Modulation
0. 6
0. 4
0. 2
0 0 0. 5 1 1. 5 2 2. 5 3 3. 5
Spatial Frequency (lp/mm)
Film Data Sheet Technical Data
T-600 Film Family
Spectral Sensitivity
Blue 1000 Green Red
100
Spectral Sensitivity
10
1
0 350 400 450 500 550 600 650 700
Wavelength (nm)
Spectral Sensitivity: Shows the equivalent energy needed at each wavelength in order to activate the emulsion so that it produces a neutral density of . 75. [. . . ]